Mass flow measurement
Showing all 5 results
-
Fall through measurement of high mass flow rates
Fall through measurement of high mass flow rates
For measurement of high mass flow rates for dry solids from the exit of pre-feeding devices,
e. g. screw conveyors, air slides, rotary valves, bucket elevators, etc.● Most non-metallic solids can be measured
● Can be installed on round pipes or ducts
● No real upper limit of mass flow
● Maximum pressure 10 bar
● Dust-tightManufactured by
CTH Industrial Controls can provide you with service and start-up assistance for SWR engineering.
-
SolidFlow 2.0 – Dry bulk solids measurement
SolidFlow 2.0 – Dry bulk solids measurement
The measuring system to easily measure the mass flow
of solids- Can be used in free fall and in pneumatics
- Simple retrofitting using a welding socket
- ATEX-certified
- Almost all types of dust, powder and granules can be measured
- No installations in the material stream
- up to 20 t/h
- Measuring principle: Microwave
- Online flow metering
- Throughput measuring up to 20 t/h
- Active roping compensation for highest reliability
Manufactured by
CTH Industrial Controls can provide you with service and start-up assistance for SWR engineering.
-
Flow metering in dense-stream
Flow metering in dense-stream
The measuring system for continuous flow metering in dense-stream conveying
and high levels of throughput- Reliable flow metering in pneumatic dense-stream
- Unlimited throughput volumes can be measured
- optionally pressure-resistant up to 25 bar
- The installation creates no obstacle in the profile, hence no dead spots in which residue can form
- Measurement independent of the flow speed of the material
- Simple retrofitting
- Maintenance-free
Manufactured by
CTH Industrial Controls can provide you with service and start-up assistance for SWR engineering.
-
Flow metering in dense-phase conveying
Flow metering in dense-phase conveying
The measuring system for continuous flow measurement for high-pressure dense phase-conveying
- Reliable flow metering in pneumatic dense-phase
- Pressure-resistant up to 110 bar
- The installation creates no obstacle in the profile, hence no dead spots in which residue can form
- Maintenance-free
- Contactless measuring procedure (no mechanics)
Manufactured by
CTH Industrial Controls can provide you with service and start-up assistance for SWR engineering.
-
Continuous flow measurement at low solid/air ratios
Continuous flow measurement at low solid/air ratios
Measuring powder flows in transport lines with very low material concentrations.
- In pneumatic applications for material flow rates of up to 100 kg/h
(depending on application) - In free-fall with a drop speed of at least 2 m/s (approx. 25 cm drop height)
- In cases where dust measuring instruments cannot cope and flow rate
measuring instruments are overspecified
Manufactured by
CTH Industrial Controls can provide you with service and start-up assistance for SWR engineering.
- In pneumatic applications for material flow rates of up to 100 kg/h
