Fall through measurement of high mass flow rates CTH | Industrial controlsCTH

Fall through measurement of high mass flow rates

For measurement of high mass flow rates for dry solids from the exit of pre-feeding devices,
e. g. screw conveyors, air slides, rotary valves, bucket elevators, etc.

● Most non-metallic solids can be measured
● Can be installed on round pipes or ducts
● No real upper limit of mass flow
● Maximum pressure 10 bar
● Dust-tight

Manufactured by

CTH Industrial Controls can provide you with service and start-up assistance for SWR engineering.

Description

Grafik zur Darstellung der Einbaulage des Sensors

The MaxxFlow HTC is specially developed for the flow measurement of dry bulk solids during high-volume throughput. Due to its completely open profile and its low installation height, the MaxxFlow HTC is especially suitable in a situation in which it was previously only possible to use complicated or expensive mechanical solutions, e. g. impact plates or measuring chutes.

The installation of the MaxxFlow HTC takes place independently of the direction of the line (vertical/inclined), but always after mechanical conveyor elements,
e. g. rotary feeder, screw conveyors, air slides or chain conveyors.