Hardy ANY-WEIGH® Bench scales


Hardy Bench Scales are available in either stainless or carbon steel base construction, with 304 Stainless Steel platters.  Choose between hermetically sealed, IP68/69K, C2 load cells and environmentally sealed, IP67 load cells, depending on your process manufacturing or commercial weighing application.


Manufactured by 


CTH Industrial Controls can provide you with service and start up assistance for your Hardy Weight System.


Click to rate this post!
[Total: 0 Average: 0]

ANY-WEIGH® Bench Scales

The Bench Scales ANY-WEIGH® provides complete flexibility in size and capacity for use in a wide range of weighing applications. With their rugged construction and stainless steel tops, ANYWEIGH Scales are a great fit for both laboratory and industrial installations.

The ANY-WEIGH line of bench scales can be configured with standard interfacing to a weight instrument or with a built-in, direct connection to a PLC or PC.

Universal Scale – HI xxxxSBU-x*
Directly attach the scale’s 15-foot cable to any weighing instrument or controller. If interfacing with a Hardy Controller, you can take full advantage of WAVERSAVER®, and C2® Electronic Calibration.

DeviceNet Scale – HI xxxxSBD-x*
With its built-in DeviceNet interface, you can use this scale to provide a weight output to any point on a DeviceNet Network. This version also incorporates both the WAVERSAVER and C2 technologies and comes with a six-inch pig-tailed connector.

Analog Scale – HI xxxxSBA-x*
Use the Analog Output Scale to provide a 4-20 mA output directly proportional to the weight reading. This version offers a low-cost, effective solution for bringing an analog weight reading directly into a control system, with minimal additional wiring or hardware, and comes with a 15-foot 2-wire shielded cable. The scale comes pre-wired and pre-calibrated from the factory but provides potentiometers for coarse and fine zero adjustments as well as span. It does not have C2 or WAVERSAVER capabilities.


ANY-WEIGH_ Bench_Scales_Datasheet